String it. Send it.Make the ball misbehave.PICK A SPOT, RUIN THE POINTString with intent.Snap strings, not sticks.String it. Send it.Make the ball misbehave.PICK A SPOT, RUIN THE POINTString with intent.

Tecnifibre · T FIGHT

T FIGHT 280 DYNACORE

16M X 20C · Identity review pending

Mains start: not confirmed

The head is listed, but it has not been matched to this exact model and generation. Don't string off it.

Two-piece routing is documented in a distributor pattern table, not an approved manufacturer route.

HEADTHROAT / HANDLE2 · FIRST CROSS 7T
01 / Mains startNot documented
02 / First cross7T
Pattern16M X 20C
Tension range49 - 55 lb
○ Hole◇ Skipped main hole (takes a cross)□ Mains tie-off⊘ Cross tie-off

Diagram template {schematic}: hole spacing is illustrative, not a measured grommet map. Hole references keep their original notation (T = head (top), B = throat (bottom)).

In words

  1. Starting end unconfirmed for this frame — confirm it on the manufacturer sheet before you start the mains.
  2. Skip 7,9T - 7,9B on the mains. Those holes are for crosses.
  3. Tie the mains off at 8B.
  4. Start the crosses at 7T and weave down.
  5. Finish the crosses at 8T - 6B.

Still missing for this frame

Exact model/generation identity match · Frame hole map and diagram review

This page is kept out of search until those are checked against the manufacturer's own instructions.

What goes in it

Once the frame is strung, the string is the variable that decides what the ball does.

SNAP SpinBite and shapeSNAP ControlA flatter, first-strike gameOne set of eachNot sureStringing guideTension guidance

String it. Send it.