String it. Send it.Make the ball misbehave.PICK A SPOT, RUIN THE POINTString with intent.Snap strings, not sticks.String it. Send it.Make the ball misbehave.PICK A SPOT, RUIN THE POINTString with intent.

HEAD · 2024 · SPEED

SPEED MP 2024

16M X 19C · Exact model match

Start mains at the HEAD

That's where the centre starting loop goes — the two centre holes at that end. It is not the first cross, and it is not the starting knot.

Two-piece routing is documented in a distributor pattern table, not an approved manufacturer route.

HEADTHROAT / HANDLE1 · CENTRE LOOP · START HERE2 · FIRST CROSS 7T
01 / Mains startHead centre loop
02 / First cross7T
Pattern16M X 19C
Tension range48 - 57 lb
○ Hole◇ Skipped main hole (takes a cross)□ Mains tie-off⊘ Cross tie-off

Diagram template {schematic}: hole spacing is illustrative, not a measured grommet map. Hole references keep their original notation (T = head (top), B = throat (bottom)).

In words

  1. Start the mains at the head. Pull the centre loop through the two centre holes at that end and work outward, one side at a time.
  2. Skip 7,9T - 7,9B on the mains. Those holes are for crosses.
  3. Tie the mains off at 8T.
  4. Start the crosses at 7T and weave down.
  5. Finish the crosses at 6T - 9B.

Still missing for this frame

Frame hole map and diagram review

This page is kept out of search until those are checked against the manufacturer's own instructions.

What goes in it

Once the frame is strung, the string is the variable that decides what the ball does.

SNAP SpinBite and shapeSNAP ControlA flatter, first-strike gameOne set of eachNot sureStringing guideTension guidance

String it. Send it.